Dell poweredge 2650 split backplane setup




















Did you mean:. Last reply by Quino Unsolved. SanLorenso 2 Iron. Any additional hints, tips, warnings, pitfalls, etc. All forum topics Previous Topic Next Topic. Reply 1. Quino 3 Argentum. It will be set correctly for termination at the factory.

Post Reply. Top Contributor. Dell Support Resources. Showing results for. Search instead for. Did you mean:. Last reply by rswarthout Unsolved. On the front backplane, it is plugged into A1. All forum topics Previous Topic Next Topic. Replies 4. Let me know the outcome.

In response to rswarthout. Hello, Do you happen to have the rear backplane, or just the front and middle? In response to Dell-DylanJ. Post Reply. Top Contributor. Dell Support Resources. View solution in original post. Does it matter what I label the container as? I just want to make sure I don't have problems later with the OS installation. The light issue makes sense, since the front bezel is broken slightly and I took it off.

The name of the container won't matter Thanks, everything's working fine now, except for the light error. I checked the BIOS and bezel intrusion was already disabled. I don't think its a major issue since everything is working fine and there's no error message. I'll just leave it as it is for now. If there is a message scrolling on the LCD panel, it can point to what the issue is. Sorry, I shut down the server for tonight but I'm almost positive that's the code.

If you only have one of the power supplies plugged in, then it will give an error for no power to the one that isn't plugged in. If it is plugged in, then it may be bad. You can try reseating the power supply - you can simply pull it out, wait 10 seconds, then put it back in. If it isn't plugged in, then you can just pull the unplugged power supply out to keep the error from showing this will require powering off with everything unplugged when you remove the power supply.



0コメント

  • 1000 / 1000